Concrete Coatings in Fontana, CA
David Paul Foster Co. applies and services coatings throughout Fontana, from the older streets near the Sierra Avenue corridor out to the newer north side tracts.
Coatings built for Fontana homes.
Fontana runs from long-settled neighborhoods with genuine industrial heritage up to newer developments on the north side. It is also one of the biggest warehouse and distribution centers in Southern California, which means a large share of our Fontana work is on floors measured in acres rather than square feet.
Warehouse and distribution floors dominate the commercial side here. Those slabs take constant forklift traffic, and the failures are predictable — abrasion down the main aisles, impact damage at the dock and racking positions, and old coatings from previous tenants that never bonded properly to begin with.
We specify to the actual traffic rather than quoting one system across a whole building. Aisles, dock areas and open storage genuinely do live different lives, and building for that is cheaper over ten years than building uniformly and replacing early.
What we run into in Fontana
On the residential side Fontana is hot and largely unshaded, particularly on the newer north side tracts, so exterior work follows the same UV logic as the rest of the inland valley: stains and textured coatings outside, epoxy in the garage.
Where we work in Fontana
- North Fontana
- Sierra Lakes
- Southridge
- Citrus Heights
Know the area
- Auto Club Speedway
- Sierra Lakes Golf Club
- Fontana Park
- 50+ years
- Licensed #641729
- 5 years material one year labor
What we do in Fontana, CA
-
FontanaConcrete Resurfacing in Fontana
Resurfacing and restoring the concrete already there — interior slabs, patios, driveways and walkways — so it looks new instead of being torn out.
Learn more → -
FontanaConcrete Coating Removal in Fontana
Stripping failed or unwanted coatings back to sound concrete — for our own jobs, and for contractors without the equipment to do it properly.
Learn more → -
FontanaEpoxy Floor Coatings in Fontana
Epoxy and flake systems laid over prepared concrete, from a single garage bay to a full commercial floor.
Learn more → -
FontanaPool Deck & Patio Coatings in Fontana
Textured, cool-to-the-touch coatings for pool decks, patios and splash pads, laid over the concrete already there.
Learn more → -
FontanaGarage Floor Coatings in Fontana
Garage and driveway floors prepared properly and finished in epoxy, flake or stain.
Learn more → -
FontanaIndustrial Floor Coatings in Fontana
Hard-wearing coatings and safety striping for machine shops, warehouses and plant floors.
Learn more → -
FontanaTennis & Pickleball Court Coating Removal in Fontana
Removing old acrylic court coatings back to the slab — the work this company started on in 1976.
Learn more → -
FontanaInterior Concrete Staining in Fontana
Interior slabs stained in copper, amber, brown, gray and terracotta tones, then sealed to a gloss or satin finish. The color goes into the concrete, so it reads like stone rather than paint.
Learn more → -
FontanaPolished Concrete in Fontana
Existing slabs ground and polished to a hard, reflective finish. There is no coating on top to peel or chip — the shine is the concrete itself.
Learn more → -
FontanaMicrotopping & Concrete Overlays in Fontana
A thin overlay applied straight over the concrete you already have — knock-down texture, flagstone, tile, brick or cobblestone patterns, without tearing the slab out.
Learn more → -
FontanaExterior Concrete Staining in Fontana
Driveways, patios, walkways and steps stained and sealed — color that soaks into the concrete rather than sitting on it.
Learn more → -
FontanaRock Staining in Fontana
Rock features, waterfalls and boulders recolored to match the deck around them, so the whole setting reads as one piece.
Learn more →
Recent work near Fontana
Colors for your Fontana project
Every color on the board, and we bring the boards to you in Fontana.
Concrete Coatings in Fontana, questions
Can you specify different systems for different areas of one warehouse?
That is usually the right answer. Aisles take abrasion, dock and racking areas take impact, and open storage takes comparatively little. One system across all of it either over-specifies most of the floor or under-specifies the parts that matter. We scope it by what actually happens where.
Do you lay the safety striping too?
Yes — aisle markings, walkway edges, bay outlines and hazard striping go in as part of the floor rather than being painted over the top afterwards, which is why they wear at the same rate as the coating around them.
How do you handle a distribution center that runs around the clock?
By phasing and working the hours you are not. Sectioning a floor and taking it in an agreed order — nights, weekends, planned shutdown windows — is standard for us. Give us the real operating constraints and we will scope to them.
Concrete advice
How to Clean and Look After a Coated, Stained or Polished Concrete Floor
A finished concrete floor needs very little, but what it needs is specific. Here is how to clean a garage floor coating, a stained interior, polished concrete and a pool deck, what to keep off them, and how to tell when a recoat is due.
Read the guide →Can Your Existing Concrete Slab Be Polished? What Decides the Result
Most slabs can be polished, but the slab decides how the floor turns out. Hardness, flatness, what is on it now, and the cracks and joints already in it all show in the finish. Here is how to read yours.
Read the guide →Staining the Concrete Under Your Carpet or Tile: What to Expect
Most Southern California homes sit on a slab that can be stained and lived on once the old flooring comes up. Here is what is usually under there, what stain hides, what it does not, and how the job runs.
Read the guide →
Other areas we serve
Ready to start your Fontana project?
Free on-site estimate, clear pricing, and a crew that shows up when we say we will.